What Size Wire for 125 Amps? — Complete NEC Guide
For a 125 amp circuit, you need 2 AWG copper wire or 1/0 AWG aluminum wire per NEC Table 310.16. Use a 125A breaker. Here is the complete sizing guide with distances, costs, and professional tips.
Common Uses for 125 Amp Circuits
Older home upgrades, medium sub-panels, small commercial service. These applications require a dedicated 125A breaker and 2 AWG copper wire (or 1/0 AWG aluminum for longer runs or cost savings).
The wire size is determined by NEC Table 310.16, which lists the maximum allowable ampacity for each conductor size based on insulation temperature rating and conductor material. For 125 amps, the minimum conductor size at 75°C insulation (the most common rating for modern wire) is 2 AWG for copper and 1/0 AWG for aluminum.
Maximum Wire Run Distance
Wire gauge determines not just ampacity but also voltage drop over distance. For a 125 amp load:
At 240V: 100 ft with 1/0 AWG AL. At 120V: N/A.
If your wire run exceeds these distances, you must upsize the wire by one or two gauges to keep voltage drop under the NEC-recommended 3% for branch circuits. Use our Voltage Drop Calculator to check your specific run.
NEC Code Reference
The 125 amp wire size requirement comes from NEC Table 310.16. This table provides ampacity ratings for insulated conductors rated 0 through 2000 volts, 60°C through 90°C, not more than three current-carrying conductors in raceway, cable, or earth. For ambient temperatures above 30°C (86°F), derating factors from NEC Table 310.15(B)(1) must be applied.
Upgrading from 100A to 125A
If your 100A panel is running out of space but your loads don't justify 200A, a 125A upgrade can be a cost-effective middle ground. This is common in older homes adding central AC or an EV charger.
Conduit vs. Romex Installation
For residential work, Individual conductors in conduit is the standard choice for concealed wiring in walls and attics. For exposed runs in garages, basements, or outdoors, use THHN 2 AWG copper or 1/0 AWG aluminum in EMT or PVC conduit. In commercial and industrial settings, individual THHN 2 AWG copper or 1/0 AWG aluminum conductors in conduit are standard.
When running in conduit with more than 3 current-carrying conductors, ampacity must be derated per NEC 310.15(C). This means the effective ampacity of 2 AWG may be less than 125A, requiring you to upsize. Use our Derating Calculator to check.
Wire Cost Estimate
2 AWG copper wire costs approximately $3.50-5.50 per foot for NM-B (Romex) cable. For a typical 50-foot run, expect to spend $25-90 on wire alone, plus breaker ($5-15), box, connectors, and labor if hiring an electrician. Aluminum wire costs roughly 40-60% less than copper for equivalent ampacity but requires larger gauge sizes.